| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
bnge: return after auxiliary_device_uninit() in error path
When auxiliary_device_add() fails, the error block calls
auxiliary_device_uninit() but does not return. The uninit drops the
last reference and synchronously runs bnge_aux_dev_release(), which sets
bd->auxr_dev = NULL and frees the underlying object. The subsequent
bd->auxr_dev->net = bd->netdev then dereferences NULL, which is not a
good thing to have happen when trying to clean up from an error.
Add the missing return, as the auxiliary bus documentation states is a
requirement (seems that LLM tools read documentation better than humans
do...) |
| In the Linux kernel, the following vulnerability has been resolved:
s390/entry: Scrub r12 register on kernel entry
Before commit f33f2d4c7c80 ("s390/bp: remove TIF_ISOLATE_BP"),
all entry handlers loaded r12 with the current task pointer
(lg %r12,__LC_CURRENT) for use by the BPENTER/BPEXIT macros. That
commit removed TIF_ISOLATE_BP, dropping both the branch prediction
macros and the r12 load, but did not add r12 to the register clearing
sequence.
Add the missing xgr %r12,%r12 to make the register scrub consistent
across all entry points. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Fix ID register initialization for non-protected pKVM guests
In protected mode, the hypervisor maintains a separate instance of
the `kvm` structure for each VM. For non-protected VMs, this structure is
initialized from the host's `kvm` state.
Currently, `pkvm_init_features_from_host()` copies the
`KVM_ARCH_FLAG_ID_REGS_INITIALIZED` flag from the host without the
underlying `id_regs` data being initialized. This results in the
hypervisor seeing the flag as set while the ID registers remain zeroed.
Consequently, `kvm_has_feat()` checks at EL2 fail (return 0) for
non-protected VMs. This breaks logic that relies on feature detection,
such as `ctxt_has_tcrx()` for TCR2_EL1 support. As a result, certain
system registers (e.g., TCR2_EL1, PIR_EL1, POR_EL1) are not
saved/restored during the world switch, which could lead to state
corruption.
Fix this by explicitly copying the ID registers from the host `kvm` to
the hypervisor `kvm` for non-protected VMs during initialization, since
we trust the host with its non-protected guests' features. Also ensure
`KVM_ARCH_FLAG_ID_REGS_INITIALIZED` is cleared initially in
`pkvm_init_features_from_host` so that `vm_copy_id_regs` can properly
initialize them and set the flag once done. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: common: st_sensors: Fix use of uninitialize device structs
Throughout the various probe functions &indio_dev->dev is used before it
is initialized. This caused a kernel panic in st_sensors_power_enable()
when the call to devm_regulator_bulk_get_enable() fails and then calls
dev_err_probe() with the uninitialized device.
This seems to only cause a panic with dev_err_probe(), dev_err(),
dev_warn() and dev_info() don't seem to cause a panic, but are fixed
as well.
The issue is reported and traced here: [1] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Fix error handling in slot reset
If the device has not recovered after slot reset is called, it goes to
out label for error handling. There it could make decision based on
uninitialized hive pointer and could result in accessing an uninitialized
list.
Initialize the list and hive properly so that it handles the error
situation and also releases the reset domain lock which is acquired
during error_detected callback.
(cherry picked from commit bb71362182e59caa227e4192da5a612b09349696) |
| Incomplete escaping of LDAP queries when running with 8bit-dns enabled allows users to perform queries of internal domain subtrees. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/ionic: Fix kernel stack leak in ionic_create_cq()
struct ionic_cq_resp resp {
__u32 cqid[2]; // offset 0 - PARTIALLY SET (see below)
__u8 udma_mask; // offset 8 - SET (resp.udma_mask = vcq->udma_mask)
__u8 rsvd[7]; // offset 9 - NEVER SET <- LEAK
};
rsvd[7]: 7 bytes of stack memory leaked unconditionally.
cqid[2]: The loop at line 1256 iterates over udma_idx but skips indices
where !(vcq->udma_mask & BIT(udma_idx)). The array has 2 entries but
udma_count could be 1, meaning cqid[1] might never be written via
ionic_create_cq_common(). If udma_mask only has bit 0 set, cqid[1] (4
bytes) is also leaked. So potentially 11 bytes leaked. |
| In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix locking for bcm_op runtime updates
Commit c2aba69d0c36 ("can: bcm: add locking for bcm_op runtime updates")
added a locking for some variables that can be modified at runtime when
updating the sending bcm_op with a new TX_SETUP command in bcm_tx_setup().
Usually the RX_SETUP only handles and filters incoming traffic with one
exception: When the RX_RTR_FRAME flag is set a predefined CAN frame is
sent when a specific RTR frame is received. Therefore the rx bcm_op uses
bcm_can_tx() which uses the bcm_tx_lock that was only initialized in
bcm_tx_setup(). Add the missing spin_lock_init() when allocating the
bcm_op in bcm_rx_setup() to handle the RTR case properly. |
| A specially-crafted file can cause libjxl's decoder to read pixel data from uninitialized (but allocated) memory.
This can be done by causing the decoder to reference an outside-image-bound area in a subsequent patches. An incorrect optimization causes the decoder to omit populating those areas. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rsi: Don't default to -EOPNOTSUPP in rsi_mac80211_config
This triggers a WARN_ON in ieee80211_hw_conf_init and isn't the expected
behavior from the driver - other drivers default to 0 too. |
| mitmproxy is a interactive TLS-capable intercepting HTTP proxy for penetration testers and software developers and mitmweb is a web-based interface for mitmproxy. In mitmproxy 12.2.1 and below, the builtin LDAP proxy authentication does not correctly sanitize the username when querying the LDAP server. This allows a malicious client to bypass authentication. Only mitmproxy instances using the proxyauth option with LDAP are affected. This option is not enabled by default. The vulnerability has been fixed in mitmproxy 12.2.2 and above. |
| Use of uninitialized resource in Windows Boot Manager allows an unauthorized attacker to bypass a security feature with a physical attack. |
| In the Linux kernel, the following vulnerability has been resolved:
xsk: Fix fragment node deletion to prevent buffer leak
After commit b692bf9a7543 ("xsk: Get rid of xdp_buff_xsk::xskb_list_node"),
the list_node field is reused for both the xskb pool list and the buffer
free list, this causes a buffer leak as described below.
xp_free() checks if a buffer is already on the free list using
list_empty(&xskb->list_node). When list_del() is used to remove a node
from the xskb pool list, it doesn't reinitialize the node pointers.
This means list_empty() will return false even after the node has been
removed, causing xp_free() to incorrectly skip adding the buffer to the
free list.
Fix this by using list_del_init() instead of list_del() in all fragment
handling paths, this ensures the list node is reinitialized after removal,
allowing the list_empty() to work correctly. |
| MISP is an open source threat intelligence and sharing platform. Prior to 2.5.36, improper neutralization of special elements in an LDAP query in ApacheAuthenticate.php allows LDAP injection via an unsanitized username value when ApacheAuthenticate.apacheEnv is configured to use a user-controlled server variable instead of REMOTE_USER (such as in certain proxy setups). An attacker able to control that value can manipulate the LDAP search filter and potentially bypass authentication constraints or cause unauthorized LDAP queries. This vulnerability is fixed in 2.5.36. |
| Unspecified vulnerability in Microsoft Excel 2000 SP3 through 2003 SP2, Viewer 2003, and Office 2004 for Mac allows user-assisted remote attackers to execute arbitrary code via crafted macros, aka "Macro Validation Vulnerability," a different vulnerability than CVE-2007-3490. |
| The Kerberos 4 support in KDC in MIT Kerberos 5 (krb5kdc) does not properly clear the unused portion of a buffer when generating an error message, which might allow remote attackers to obtain sensitive information, aka "Uninitialized stack values." |
| Microsoft Internet Explorer 7 for Windows XP SP2 and SP3; 7 for Server 2003 SP2; 7 for Vista Gold, SP1, and SP2; and 7 for Server 2008 SP2 does not properly handle objects in memory, which allows remote attackers to execute arbitrary code by calling the setCapture method on a collection of crafted objects, aka "Uninitialized Memory Corruption Vulnerability." |
| Opera before 9.52 on Windows, Linux, FreeBSD, and Solaris, when processing custom shortcut and menu commands, can produce argument strings that contain uninitialized memory, which might allow user-assisted remote attackers to execute arbitrary code or conduct other attacks via vectors related to activation of a shortcut. |
| sockethandler.cpp in HTTP Antivirus Proxy (HAVP) 0.88 allows remote attackers to cause a denial of service (hang) by connecting to a non-responsive server, which triggers an infinite loop due to an uninitialized variable. |
| The ippReadIO function in cups/ipp.c in cupsd in CUPS before 1.3.10 does not properly initialize memory for IPP request packets, which allows remote attackers to cause a denial of service (NULL pointer dereference and daemon crash) via a scheduler request with two consecutive IPP_TAG_UNSUPPORTED tags. |
